Automatic bandsaw FMB PEGASUS+CN

• Head structure in 3 parts: special aluminium alloy, steel and cast iron.
• Dynamometric blade tensioning.
• Broken blade micro and blade rotation sensor.
• Head feeding system with hydraulic cylinder and front balanced valve for feeding regulation and cutting optimizing.
• The head rotation is fully programmable from the operator control panel, the rotation done with a hydraulic cylinder and the cutting angle read by a magnetic band.
• Once the head is at the programmed angle, the head is hydraulically locked in position via a hydraulic cylinder.
• Blade guide with combined action of side bearings, carbide plates and top bearing.
• Direct drive: Reduction gear box with inclined grinded case hardened teeth lubricated with long lasting grease.
• Inverter VHZ for a wide range of speed selection.
• Motorized blade cleaning brush driven by motor gearbox.
• Material clamping vices with rack system, manual positioning and hydraulic stop cylinder.
• Carriage vice for material feeding equipped with hydraulic cylinder and self-centric device for not straight bars.
• Material lacking micro placed on the carriage vice.
• Automatic positioning of the feeding vice to the programmed measure for singular and multiple indexing.
• The accuracy of the system is ± 0,2 mm.
• The feeding slides on linear rails so to reduce friction.
• The singular feeding stroke is of 1000 mm. Traslation speed of 4,2 m/min.
• The length of final scrap in automatic cycle is 310 mm.
• N° 4 rollers are positioned between the entry of the machine basement and the front vice so to support the material.
• The two central rollers are positioned in automatic depending on the position of the feeding vice; the advantage is a better support of short bars.
• Heavy duty basement with sheet metal construction in different thickness, chips holding system and integrated coolant tank.
• NB1 standard device which allows to effect the material cut through a soft lubrication of the blade cutting edge.
• Ergonomic working table and control panel.
• Roller table connected to the machine for material support in loading side - length 1000 mm.
• Plan rollers in the exhaust side to support the material during the cutting rights.
• Hydraulic unit for the head, head support clamping, vices, carriage feeding cylinders’ power supply.
• Electrical cabinet with 24VAC, lockable main switch.
• Digital control panel to check all machine functions, cutting cycles and auto diagnostic function.
• Total protection against highest voltage and short circuit current. Protection level IP 55.
• Electrical cabinet with 24VAC, main switch and safety unit.
• Total protection against highest voltage and short circuit current.
• Protection level IP 55.
• Line voltage: 400V/50Hz/3Ph standard (230V/50Hz/3Ph-220V/60Hz/3Ph-440V/60Hz/3Ph-575V/60Hz/3Ph available).
• Machine colours: yellow RAL 1018 and grey RAL 7036.